Sabrent SBT-RDIT Silicon Image Ultra ATA 100/133 IDE RAID PCI Controller Card
Zip Code:
Calculate Shipping Rates Here!
Sabrent SBT-RDIT ATA 100/133 IDE RAID PCI Controller Card
This card is stand-alone 100/133 PCI to IDE/ATA host controller is the perfect single chip solution for designs based on chipsets without an integrated IDE host controller or designs which need to expand the number of IDE channels to accommodate the growing number of storage peripherals with IDE interface.
Any system with a PCI bus interface can simply add the 100/133 IDE/ATA interface by adding a card with the PCI card and loading the driver into the system.
Features
Achieves High-Speed data Transfer Rates up to 133/100MB/sec
Internal 32 bit PCI Card
ADD 2 Ultra ATA 133/100 ports
Supports ULtra ATA 133/100/66/33, EIDE/Fast ATA 2 IDE & ATAPI Devices
Coexists with on board IDE ports and connects up to 4 IDE/ATAPI Devices
Specifications
- 2 independent IDE/ATA channels
- Supports up to 4 IDE/ATA devices
- Supports Ultra and multiword DMA timing modes
- CRC (Cyclical Redundancy Check)
- 128 bytes buffer
- Built in 80-pin cable detect circuitry
- Supports External BIOS
- Supports bus master DMA at 133 MB/sec PCI burst rate
- Supports maximum IDE/ATA data transfer rate of 66 MB/sec (100MB/sec)
- 3.3V Operating Voltage with 5V tolerant I/O
Regular price: $49.99 Sale price: $44.99 Cables Unlimited Ultra ATA 133 RAID PCI Controller Card
Specifications Ultra DMA 133MB operation per ATA channel Supports up to 66MHz PCI bus clock Supports PCI 2.2 Two independent ATA channels per one PCI function Dedicated ATA bus Independent ATA clock from PCI bus 256 Byte FIFO per ATA channel Independent large FIFO Supports all ATAPI CD ROM, DVD ROM, CD-R, CD-RW, LS-120, MO, Tape and Zip devices Easy Plug and Play feature Supports up to four IDE devices (coexists with on-board IDE) Supports hard drive with capacity larger than 30GB Supports RAID function (RAID 0, 1, 0+1) Supports Windows 95, 98, NT 4.0, 2000, XP and DOS Supports booting function with Flash Memory interface Automatically fine tunes to the best performance for each ATAPI/IDE device Concurrent PIO and bus master access (ATA port accessible during DMA transfer) Small foot print 144-pin LQFP package (dedicated parallel EPROM pins) Embedded serial resistor on chip for ATA specification
|
Regular price: $24.99 Reliable and Eye-Pattern Proven
Minumum System Requirements
Specifications Provides 2 Brackets to Support Low profile PCI and Regular size PCI in one card Breaks Capacity-Limit to Support HDD larger than 137GB Dual high speed Serial ATA interface ports, each supporting 1st generation Serial ATA data rates 1.5Gb/s Fully compliant with Serial ATA 1.5G specifications Provides RAID 0 (Stripping) to greatly increase the performance of data transfer by simultaneously writing data to 2 drives Provides RAID 1 (Mirroring) to protect the data from a disk failure by writing identical data on 2 drives Supports Spread Spectrum in receiver Independent 256-byte FIFOs (32 bit * 64 deep) per Serial ATA channel for host reads and writes Compliant with PCI Specification, revision 2.2 Integrated PCI DMA engines 32 bit, 33/66MHz fully compliant PCI host interface Complete with drivers for Windows 98, Windows Millennium, Windows NT 4.0, Windows 2000 and XP Acts as NON-RAID when not BIOS configured RAID RoHS Compliant
|
 |  |
© Copyright 2009 PC Power Zone. All Rights Reserved.
Website Design by Solid Cactus